camber
英 ['k?mb?]
美['k?mb?]
- vt. 外傾角；使拱起；使彎作弧形
- n. 弧形；小船塢；曲弧度
- vi. 成弧形；使拱起
- n. (Camber)人名；(法)康貝；(瑞典)坎貝爾
實用場景例句
- The automatic camber control system of the line is introduced completely in the paper.
- 本文將對該生產線的自動凸度控制系統作全面詳細的介紹.
期刊摘選
- The tilt of the wheel ( camber ) is measured in degrees and is adjustable on many vehicles.
- 該輪 ( 彎度傾斜 ) 是衡量度,是許多車輛可調.
期刊摘選
- The larger permeability damage modulus and the earlier the IPR curving and the camber was.
- 滲透率傷害系數越大,曲線彎曲越早,彎曲度越大.
期刊摘選
- A taper has two sides, the underside is a circle, the flank is a camber.
- 結論:圓錐有兩個面, 底面是一個圓形, 側面是一個曲面.
期刊摘選
- The front subframe is modified for extra camber and castor.
- 前副車架被修改為額外拱形和蓖麻.
期刊摘選
- This provides an increased damping rate and allows a slight reduction in camber angle.
- 這樣就增加了減震度,并且可以稍微減少外傾角.
期刊摘選
- Application of low Mooney viscosity, non pollution type NBR to thin camber sponge rubber was studied.
- 研究低門尼粘度 、 非污染型丁腈橡膠在薄型曲面海綿膠料中的應用.
期刊摘選
- Camber line won " ts do orthogonal arc tooth wimble gear. "
- 中心線 不成 直角的弧齒錐齒輪.
期刊摘選
- The measures for improving wear of camber for lockup were proposed.
- 針對鎖緊弧面的磨損提出了改善措施.
期刊摘選
- The camber is curvature of the cross section and the crown is the highest point camber.
- 圖中向上傾斜部分是路拱,該部分的最高點是路脊.
期刊摘選
- In this thesis the basic aspects about forming process of camber die are studied etically.
- 本論文對曲面凹模成形工藝的若干問題進行了系統的理論分析.
期刊摘選
- Inward tilt is negative camber and outward tilt is positive camber.
- 向內傾斜,是消極的拱和拱向外傾斜是積極的.
期刊摘選
- " To Camber Company, please . It's on 32 nd avenue . "
- 去 坎培克斯 公司. 在第32街上.
英漢 - 翻譯樣例 - 口語
- Long lengths of unsupported strip camber tend to deviate from the horizontal or slope to side.
- 長距離無支持的鋼帶偏離水平線或偏向一側.也可參見以下部分.
期刊摘選
- The superstructure a depth of 3 ft . 6 in. a marked camber of 19 ft . 8 in.
- 上部結構的建筑高度為3英尺6 英寸,有19英尺8 英寸 顯著的上拱度.
期刊摘選
- I can see a point, a circle and a camber.
- 生:有一個點, 有一個圓,還有一個曲面.
期刊摘選
- Determine the camber factor.
- 確定曲面的因素.
期刊摘選
- It has two sides, one is a circle, the other is a camber.
- 生:圓錐有兩個面, 一個面是圓形, 另一個面是曲面.
期刊摘選
- The method also permits inverse design with flaps , specification of geometric constraints ( thickness , camber, etc. ).
- 比如開發了邊界層的形狀參數,可以指定允許的最高表面上取消或延期舉辦層流 、 乎設計要求.
期刊摘選
- The joint of all the camber will be the camber curve.
- 各截面凸度連線便是凸度曲線.
期刊摘選
- At present , the experience method of installing the camber has many problems.
- 經驗法設置大跨徑連續剛構橋預拱度存在諸多問題.
期刊摘選
- The thermal camber of rolls is a very important factor affecting distribution of hot strip mills.
- 軋輥熱凸度是影響熱帶鋼連軋機負載輥縫的重要因素,高效率的工作輥冷卻水系統是生產高質量熱軋板帶的重要保證.
期刊摘選
- Camber is the inward or outward tilt of the wheel at top.
- 坎貝爾是在方向盤向內或向外傾斜的頂部.
期刊摘選
- Second, the camber equation is developed for the crss points.
- 從曲面方程和直線方程的聯立解求出交點.
期刊摘選